How can I SmartSnap a dimension to the center of an arc or circle?
Hold the Shift key while selecting the arc or circle. This works in Scenes and Drawings.
Related Articles
What video card should I use with IronCAD?
Any VGA card will work but for best performance try a card from one of these model lines: Nvidia Quadro AMD FirePRO Or any card with good OpenGL hardware acceleration I cannot dimension the radius or diameter of an arc or circle. This is a common ...
Multiphysics for IronCAD Product Specification
Attached is a table showing the various capabilities in each product in the Multiphysics for IronCAD package. Product Packages: MP Starter/Trial - Trial version of the MPIC and continues to run after the trial in the 2000 Node mesh limit. MP Lite - ...
Create unlocked "measurement" dimensions on a Sketch
Some users may want to measure geometry on their Sketch by placing dimensions that aren't constraints. The Sketch SmartDimension command by default creates locked constraint dimensions. If you want unlocked dimensions, start the SmartDimension ...
IronCAD Public Access SDK Technical Manual for Non-Runtime Access to IronCAD Data
The IronCAD Public SDK allows a user to access information about their IRONCAD file without needing to open the software itself. The user will have access to information such as file properties, file GUIDs, part/assembly properties, and file ...
Setting up single key keyboard shortcuts in CAXA Draft
A little trick if you want to setup single key keyboard shortcuts in CAXA Draft such as L for line or C for circle. Right-click a blank area next to the ribbon bar and go to Custom. Then select the "Keyboard instruction" tab (not Keyboard, that is ...