IronCAD Mechanical Lite Features

IronCAD Mechanical Lite Features

IronCAD Mechanical Lite is a yearly subscription product that can be added as a yearly license to a perpetual IronCAD NU (or Sentinel NLM License). IronCAD Mechanical Lite is also included in some of the Enterprise Yearly licenses. As this is a lite version, there are commands that are not accessible in the full IronCAD Mechanical. Below are the included features. 

IronCAD Mechanical Lite Features:  

IronCAD Mechanical  

Tools:  

  1. Fasteners  

  1. Fastener Assembly  

  1. Holes  

  1. Update Fastener Holes  

  1. Retaining Rings  

  1. Rings  

  1. Holder Rings  

  1. Bearings  

  1. Springs  

  1. Gears  

  1. Boss Thread Standard  

   

Structural Steel:  

  1. Standard Steel  

  1. Steel Cap  

  1. Tube Cap  

  1. Quick Trim  

  1. Extend Steels  

   

Process Tools:  

  1. Face to DXF   

  1. Proactive Manager (Reduced Functionality)  

  1. Add Attachment  

  1. Add Post-It  

  1. Ghost Manager  

  1. Suppression Manager  

  1. Hide Elements  

  1. View Manager  

  1. Set Status   

  1. Set Material  

   

Ribbon Bar and Installations:  

  1. Basically, some of the setup tools that is provided will still need to be available for the Subscription model that are found in the Start Menu and on the IC Mech Ribbon Bar.   

    • Related Articles

    • Multiphysics for IronCAD Lite

      We are excited to announce the launch of Multiphysics for IronCAD Lite, a new yearly subscription add-on designed to enhance the IronCAD perpetual license with accessible, powerful static stress analysis capabilities. This product provides an entry ...

    • What free utilities are within IronCAD Mechanical

      IronCAD Mechanical provides many tools for designers and engineers but some of you may not know that some basic functionality is available in IronCAD Mechanical even without a license. The following will all work even after the trial license has ...

    • Add Notes to a part with IronCAD Mechanical

      With the IronCAD Mechanical addon you can add Notes to parts. Drag and drop the "Add Post-It Note" catalog item onto a part. Add your Note and click OK. Then you will see a Note symbol on the part. You can right-click the part to open the Note.

    • Multiphysics for IronCAD Product Specification

      Attached is a table showing the various capabilities in each product in the Multiphysics for IronCAD package. Product Packages: MP Starter/Trial - Trial version of the MPIC and continues to run after the trial in the 2000 Node mesh limit. MP Lite - ...

    • IronCAD Manual Uninstall

      This is to be performed only when you are unable to uninstall from the Windows Control Panel. DISCLAIMER: Editing the Windows Registry can be dangerous. If the wrong registry key is deleted it can cause Windows to stop functioning in a variety of ...