PIN-SLOT Constraint limitation notes
The new Pin/Slot Constraint does have a limitation that is often asked about. The current constraint supports closed regions. It currently does not support open ended slots as shown below.
Supported slots:
Unsupported Slots:
Related Articles
How to turn off automatic Sheet Metal punch/form constraints
Some users may find the automatic sheet metal punch/form constraints bothersome. To turn them off, go to Options, Sheet Metal, and toggle off "Create punch and forming constraints".Mechanism Mode Dragging Behavior options explained
Standard The solver will attempt to find a solution that localizes the changes around the nodes being dragged. The movement of the dragged nodes will not be “propagated” to nearby nodes. Adjacent sets and geometries within a model may be moved ...How to improve performance when importing a large DWG or DXF in a Sketch
Sometimes when importing a large DWG or DXF to a 2D Sketch, the amount of geometry can cause the graphics performance to decrease. This is partly due to the large number of profile condition locators and constraint symbols on the geometry. To improve ...Transferring an IronCAD Named User (NU) License to Another Machine
This article provides step-by-step instructions for transferring an IronCAD Named User (NU) License from one machine to another using the IronCAD License Management Tool. Prerequisites Ensure you have administrative access to both the source and ...Multiphysics for IronCAD Product Specification
Attached is a table showing the various capabilities in each product in the Multiphysics for IronCAD package. Product Packages: MP Starter/Trial - Trial version of the MPIC and continues to run after the trial in the 2000 Node mesh limit. MP Lite - ...